#include <db.h> int DB_ENV->get_verbose(DB_ENV *dbenv, u_int32_t which, int *onoffp);
The DB_ENV->get_verbose()
method returns whether the specified
which parameter is currently set or not. These parameters
are set using the
DB_ENV->set_verbose()
method.
The DB_ENV->get_verbose()
method may be called at any time during the life of the application.
The DB_ENV->get_verbose()
method returns a non-zero error value on failure and 0 on success.
The which parameter is the message value for which configuration is being checked. Must be set to one of the following values:
Display additional information when doing backup.
Display additional information when doing deadlock detection.
Display additional information when performing filesystem operations such as open, close or rename. May not be available on all platforms.
Display additional information when performing all filesystem operations, including read and write. May not be available on all platforms.
Display additional information when performing recovery.
Display additional information concerning support for the DB_REGISTER flag to the DB_ENV->open() method.
Display all detailed information about replication. This includes the information displayed by all of the other DB_VERB_REP_* and DB_VERB_REPMGR_* values.
Display detailed information about replication elections.
Display detailed information about replication master leases.
Display detailed information about general replication processing not covered by the other DB_VERB_REP_* values.
Display detailed information about replication message processing.
Display detailed information about replication client synchronization.
Saves replication system information to a system-owned file. This value is on by default.
Display detailed information about Replication Manager connection failures.
Display detailed information about general Replication Manager processing.
Display detailed information about all Replication Manager SSL processing.
Display detailed information about Replication Manager SSL connection setup (connect and accept) and shutdown processing.
Display detailed information about Replication Manager SSL connection IO (reads and writes).
Display the waits-for table when doing deadlock detection.